The combination fuel filter/pressure regulator is located in front of the fuel tank and above the rear axle. It is transversely mounted to a chassis crossmember (left-to-right). The filter/regulator is equipped with 3 fuel line fittings (2 at one end and 1 at the other end). The single fitting facing the left side of the vehicle is the supply line to the fuel rail. The 2 fittings facing the right side of the vehicle are connected to the fuel tank. Of these 2 fittings, the fitting towards the front is used for fuel return to the fuel tank. The fitting towards the rear is a pressure line.

External filter/regulator removal

1. Remove fuel fill cap.
2. Remove fuel pump relay from Power Distribution Center (PDC). For location of relay, refer to label on underside of PDC cover.
3. Start and run engine until it stalls.
4. Attempt restarting engine until it will no longer run.
5. Turn ignition key to OFF position.
6. Disconnect negative battery cable at battery.
7. Raise vehicle.
8. Clean area around 3 filter/regulator fittings.
9. Disconnect fuel supply, fuel return and fuel pressure lines at filter/regulator. Special tools may be required, see "Quick-Connect Fittings" (PDF file).
10. Remove 2 mounting bolts and remove filter/regulator.

External filter/regulator installation

1. Before installing filter/regulator, be sure all fittings are cleaned of all dirt and contaminants.
2. Be sure o-ring is positioned into fuel return fitting in filter/regulator.
3. Apply a small amount of clean engine oil to o-rings.
4. Position filter/regulator to body and install 2 bolts. Tighten bolts. Refer to Torque Specifications.
5. Connect 3 fittings. Refer to Quick-Connect Fittings PDF file.
6. Connect negative battery cable to battery.
7. Start engine and check for leaks.

Fuel pump/sending unit